Water is flowing back into the dishwasher
Issue
- Water is flowing back into the dishwasher. The problem is caused by the drain hose.
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
1. Ensure that the drain hose has been installed correctly.
Make sure that:
- The length of the drain hose does not exceed 400 cm.
- The drain inlet point must be between 40 and 85 cm.
- The drain hose is not damaged, kinked or twisted.
2. Contact an Authorized Service Center.
If the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Note: The multi-tablet function must be enabled after you select a cycle and will not be saved in the memory.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- How To Raise Dishwasher Upper Basket
- Dishwasher comfort lift basket stuck in the UPPER position
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- How to adjust water hardness level in dishwasher
- There is a lot of foam in my dishwasher
- Dishwasher displays error code i30
- Dishwasher does not switch on, no light on the control panel
- Dishwasher does not / will not start but the power is on
- Integrated built-in dishwasher door stuck closed
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher