Dishwasher displays error code i40, i43 or i44
Issue
- Dishwasher displays error code i40, i41, i43 or i44
- Dishwasher emits 4 beeps / 4 flashes
Applies to
- integrated dishwasher
- freestanding dishwasher
Resolution
1. Reset your appliance.
Remove the plug for the dishwasher and plug it in again after approximately 5 minutes.
You can also turn off the power using the fuses on the panel/power switch.
2. Check your dishwasher filter and sump (see the instructional video below) for signs of foam/suds & debris
How To Clean Your Dishwasher Filter
- Make sure you clean all the filters
- Clear any foam/suds from the sump
- Plug the appliance back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
Still need help? Get expert support
If the issue continues, a professional technician can help diagnose and fix the problem.
No matter if your appliance is in warranty, out of warranty, or covered by an appliance protection plan - we’ll guide you to the right service.
Cause
- i40 error message indicates a potentail fault in the pressure sensor and water level control
Was this article helpful?
Related Articles
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Dishwasher does not beep at the end of the cycle
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code iF0, iFo or iF1
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- Dishwasher displays error code i30
- Dishwasher does not dry or dries poorly
- Water is being filled into the dishwasher even when it is turned off
- How to adjust water hardness level in dishwasher
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Dishwasher does not beep at the end of the cycle
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code iF0, iFo or iF1
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- Dishwasher displays error code i30
- Dishwasher does not dry or dries poorly
- Water is being filled into the dishwasher even when it is turned off
- How to adjust water hardness level in dishwasher