Dishwasher is leaking
Issue
- Small leak from the dishwasher door
- Leaks under the dishwasher during use
- Water (of foam) comes out of the door at the bottom or front
- Water below the dishwasher
- Dishwasher displays error code i30 - water leak detected
Applies to
- Freestanding dishwasher
- Built-in dishwasher
Resolution
The dishwasher could be leaking due to the below:
The dishwasher is not levelled correctly:
- Check the appliance is levelled correctly with a spirit level.
- Loosen or tighten the adjustable feet (if applicable).
- The appliance door is not centred on the tub. Adjust the rear foot (if applicable).
- For more information on levelling your machine refer to the user manual supplied with your appliance.
There is a kink, block or disconnection in the pipes:
- Pull the machine out to check all pipes behind the machine are free from kinks or blockages.
- Follow each pipe from dishwasher to tap to ensure there are no disconnections visible and that all seals are dry.
There may be a split in the pipe or water seal:
- Pull the machine out to check all pipes behind the machine
- Follow each pipe to ensure there are no kinks or disconnections visible
- Check the water seal thoroughly to check for breaks or erosion
Spray arm rotation impeded or large item deflecting water jet:
- Check the spray arms and filters and clean them if necessary
How to clean your dishwasher filter
How to clean your dishwasher spray arms
- Occasionally a large item may block or impede the spray arm rotation, leading to water being sprayed consistently in one position only, this may put undue pressure on one area of the door seal and lead to inundation and leaking in that particular area.
- Check the loading and ensure the spray arms can rotate freely and that no unusually large item is either blocking movement, or perhaps deflecting water spray into a corner of the dishwasher, or back onto the internal door panel.
- After adjusting the load and/or removing the large item, leave the machine overnight with the water tap turned off, to allow the base to dry out a little and try again the next day.
Over-foaming - possibly washing-up liquid has been used
- To rectify the problem refer to the article There is a lot of foam in my dishwasher
To book an engineer visit please click 'Book a repair' on this page.
Was this article helpful?
Related Articles
- Dishwasher does not switch on, no light on the control panel
- Dishwasher shows d: on in display / DEMO mode deactivation
- Dishwasher displays an error code, how to fix it?
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Program not starting and cycle indicator light flashing on dishwasher
- Compact dishwasher displays error message E4
- Dishwasher displays error code i40, i43 or i44
- Dishwasher door will not stay open
- Dishwasher salt consumption is too high
- Water is being filled into the dishwasher even when it is turned off