Zanussi Washing Machine Displays an Error Code – How to Fix It?

Issue

If your Zanussi washing machine shows an error code, if the lights are flashing and the machine is beeping, or if the wash cycle stops unexpectedly, the washing machine has detected a problem and is asking for attention.

In many cases, the issue can be resolved without service by checking the meaning of the error code and following the recommended steps.

Typical signs:

• An error code appears on the display
• The washing machine stops during a programme
• The washer dryer beeps repeatedly
• LEDs flash in a pattern
• Water remains in the drum
• The door stays locked

Applies to

• Zanussi Washing Machines
• Zanussi Washer Dryers

Resolution

Start by checking the most common causes of the problem. In many cases, the issue can be resolved without service.

Find your error code below and follow the relevant guide:

• Error code E10 or similar (water supply problem)
• Error code E20 or similar (draining problem)
• Error code E30 or similar (water pressure sensor problem)
• Error code E40 or similar (door lock problem)
• Error code E50 or similar (motor problem)
• Error code E60 or similar (heating problem)
• Error code EF0 or similar (water leakage, over-foaming, imbalanced load)
• Error code EH0 or similar (power supply problem)

If you cannot find your error code:

1. Write down the full error code shown on the display.
2. Visit the Zanussi Support page.
3. Enter the code in the search field.
4. Open the article that matches your code.
5. Follow the recommended checks.

Important

• Error codes may vary between models.
• Always note the full code before disconnecting power.
• Refer to the user manual if your washing machine has model-specific functions.
• If the same code keeps returning, further checks may be required.

When Is It A Genuine Fault?

In these situations, there may be a fault with the washing machine:

• The error code returns after troubleshooting.
• The washing machine will not start.
• The drum does not turn.
• The washing machine does not fill or drain properly.
• Water is leaking from the washing machine.
• Several error codes appear at the same time.

Book a Service

If your Zanussi washing machine continues to experience problems, our specially trained technicians can quickly identify the fault and help restore correct operation.

Book repair service online

Cause

Error codes help the washing machine identify a specific problem. When the control system detects something unusual, it stops the programme and displays a code.

The most common causes are:

• Water supply problems
• Drainage problems
• A blocked pump or filter
• Door lock issues
• Motor faults
• Heating faults
• Excessive detergent foam
• Power supply issues

The error code helps identify the area affected so the correct checks can be carried out.

FAQ – Washing Machine Error Codes

Why is my Zanussi washing machine showing an error code?

The washing machine has detected a problem and is displaying a code to help identify it.

What does E10 mean on a Zanussi washing machine?

E10 usually indicates a water supply problem.

What does E20 mean on a Zanussi washing machine?

E20 usually indicates a drainage problem.

Why is my washing machine flashing lights and beeping?

Flashing lights and beeps are used to indicate a detected issue.

Is it normal for the washing machine to stop when an error code appears?

Yes. The washing machine may stop a programme to prevent further problems.

Do I need to book a repair for every error code?

No. Many error codes can be resolved by following the relevant troubleshooting guidance.