Tumble dryer displays error code E9E
Issue
- Tumble dryer displays error code E9E
Applies to
- Tumble dryers
Resolution
- Check main power supply, switch off other running appliances if necessary
- The appliance is probably placed in a small closed storage room and is overheating or the air is heavy with moisture due to the lack of ventilation. Make sure that the appliance is installed in an environment with sufficient air exchange
- Clean the fluff filter and the heat exchanger area. Clean the filter after each drying cycle. Refer to the article: Cleaning tumble dryer filters and condenser
Cause
- Electrical noise
- Humidity/water on UI board
Was this article helpful?
Related Articles
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer ends the programme immediately after the start
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E60 and does not heat up
- Condenser tumble dryer taking too long to finish
- Light in the drum of the tumble dryer does not work
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer ends the programme immediately after the start
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E60 and does not heat up
- Condenser tumble dryer taking too long to finish
- Light in the drum of the tumble dryer does not work
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off