Tumble dryer ends the programme immediately after the start
Resolution
Issue:
- Tumble dryer ends the programme immediately after the start
- The dryer starts briefly but jumps to the end
- The laundry is not dried
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Do not put dry laundry in the appliance. Always use a time-controlled program to dry slightly damp laundry.
Note: Always choose a short drying time, otherwise the laundry could overheat and shrink!
Note: Never leave the dryer empty or with little laundry!
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Cause
1. Tumble dryer programmes are essentially either time-controlled or humidity-controlled.
For moisture-controlled programmes, such as cotton cupboard dry or iron dry, a conductivity measurement is performed at the beginning, which measures the moisture in the laundry. If the humidity in the laundry is too low or there is no or too little laundry in the appliance, the humidity can not be determined and the programme is cancelled.
Was this article helpful?
Related Articles
- Tumble Dryer Has No Power or Does Not Start
- Tumble dryer displays error message "Err"
- Tumble dryer damages clothes
- The handle for opening the tumble dryer is broken
- Tumble dryer is leaking
- Tumble dryer emits unpleasant smells
- Tumble dryer not drying, not drying properly, too long drying
- How to change the dryer door opening directions?
- Tumble Dryer displays error code E50 - Causes and Solutions
- Tumble dryer's drying results are poor and laundry is damp after drying
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Tumble Dryer Has No Power or Does Not Start
- Tumble dryer displays error message "Err"
- Tumble dryer damages clothes
- The handle for opening the tumble dryer is broken
- Tumble dryer is leaking
- Tumble dryer emits unpleasant smells
- Tumble dryer not drying, not drying properly, too long drying
- How to change the dryer door opening directions?
- Tumble Dryer displays error code E50 - Causes and Solutions
- Tumble dryer's drying results are poor and laundry is damp after drying