Tumble dryer blows fuses / trips RCD circuit breaker
Issue
- Tumble dryer blows fuses / trips RCD circuit breaker
Applies to
- Tumble dryer
- Washing machine
Resolution
If the tumble dryer blows fuses / trips RCD circuit breaker, refer to the suggestions below for step by step instructions.
Warning:
- Do not connect a washing machine and a tumble dryer to the same fuse circuit. The power required by the two appliances combined would exceed 13 amps.
- Never use an extension cable to connect appliances, as this may cause a short-circuit or fire hazard.
- When an RCD circuit breaker trips or a fuse blows when you switch the appliance on or off, this is usually caused by leakage to ground or a short-circuit.
- The problem can be caused by incorrect connection of the appliance. Plug in the appliance somewhere else.
- If several appliances are connected to the same fuse circuit, this could cause the fuse to blow or the RCD circuit breaker to trip.
If the above suggestions do not resolve the problem, contact Authorized Service Center.
Was this article helpful?
Related Articles
- Clothes are still wet at the end of the drying cycle
- Wool clothes have shrunk after the drying cycle
- Cleaning tumble dryer filters and condenser
- Twisted Laces in the Dryer
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer displays error message "Err"
- Condenser Dryer Drain Kit
- Tumble dryer displays error message EHO, EH0
- Water leakage from under the dryer