Tumble dryer displays error message E50
Resolution
Issue:
- Tumble dryer displays error message E50. It indicates a motor or software problem.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
2. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up
- Water leakage from under the dryer
- Cleaning tumble dryer filters and condenser
Related Articles
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up
- Water leakage from under the dryer
- Cleaning tumble dryer filters and condenser