Tumble dryer displays error code E9E
Issue
- Tumble dryer displays error code E9E
Applies to
- Tumble dryers
Resolution
- Check main power supply, switch off other running appliances if necessary
- The appliance is probably placed in a small closed storage room and is overheating or the air is heavy with moisture due to the lack of ventilation. Make sure that the appliance is installed in an environment with sufficient air exchange
- Clean the fluff filter and the heat exchanger area. Clean the filter after each drying cycle. Refer to the article: Cleaning tumble dryer filters and condenser
Cause
- Electrical noise
- Humidity/water on UI board
Was this article helpful?
Related Articles
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off
- Tumble dryer's Condenser LED is on
- Cleaning tumble dryer filters and condenser
- Condenser Dryer Drain Kit
- Clothes are still wet at the end of the drying cycle
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble Dryer Has No Power or Does Not Start
- Tumble dryer displays error message "Err"
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off
- Tumble dryer's Condenser LED is on
- Cleaning tumble dryer filters and condenser
- Condenser Dryer Drain Kit
- Clothes are still wet at the end of the drying cycle
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble Dryer Has No Power or Does Not Start
- Tumble dryer displays error message "Err"