Tumble dryer displays error message "Err"
Resolution
Issue
- Tumble dryer displays error message "Err". It appears when there is an attempt at changing a cycle or settings after the cycle has started or chosen option cannot be used with the selected cycle.
Applies to
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution
1. Switch the dryer off and on, then select the desired cycle and options.
Additional information can be found in the user manual.
Download the .
2. Make sure that the door is fully closed before starting the programme.
Was this article helpful?
Related Articles
- Cleaning tumble dryer filters and condenser
- Tumble dryer's door will not open or is defective / broken
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message EHO, EH0
- Clothes are still wet at the end of the drying cycle
- Tumble dryer emits unpleasant smells
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer displays error message E50
- Tumble dryer stops after a few minutes of the cycle
- Tumble dryer ends the programme immediately after the start