Tumble dryer displays error code E70
Issue
- Dryer shows error message E70 on the display
- E70 code on tumble dryer
Applies to
- Dryers
Resolution
1. Reset the appliance's control electronics by unplugging the appliance for 2 hours and then plugging it back in.
2. If this does not solve the problem and the error persists, contact our Consumer Care Centre
A service visit by one of our approved service providers is recommended.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Cause
- Error code E70 indicates a problem with the temperature sensor
Was this article helpful?
Related Articles
- Cleaning tumble dryer filters and condenser
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Drying Temperature in Heat Pump Tumble Dryer
- Tumble dryer not drying, not drying properly, too long drying
- Clothes are still wet at the end of the drying cycle
- Tumble dryer’s water tank is empty
- Tumble dryer stops after a few minutes of the cycle
- Condenser Dryer Drain Kit
- Tumble dryer displays error message E40
- Tumble dryer displays error message EHO, EH0