Washing machine's door can be opened and water runs out onto the floor
Resolution
Issue:
- Washing machine's door can be opened and water runs out onto the floor
Applies to:
- Front loaded washing machine
Resolution:
1. Start a draining cycle before turning off the machine and opening the door, otherwise the water will run out onto the floor.
2. Contact an Authorized Service Center.
If the door can be opened with water in the machine and the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- If a wash cycle with a "Rinse Hold" was chosen and the machine was turned off by using the cycle selector or disconnecting it from the power, the door can be opened after a few minutes, even though there is water in the machine.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Washing machine does not work / does not react
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- Washing machine’s fluff filter is jammed, cannot be removed
- Washing machine stops in the middle of a cycle
- The door of the washing machine cannot be opened
- Washing machine displays an error code, how to fix it?
- Zanussi washing machine does not take detergents / water remains in the softener compartment
- Fabric conditioner does not dissolve in my washing machine
- How to stop your washing machine vibrating and reduce noise / unbalanced load / reduce vibration during rinse
- Washing machine displays "CLE" - drum cleaning reminder