Dishwasher - How to replace the door lock (1)
Applies to
- Dishwashers
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE ROUND SEAL, CONTAINER CUP
1. Unscrew the four PH2 screws holding the bottom cover of the dishwasher and then pull the cover towards you to remove.
2. Unscrew the two PH2 screws on the top of the left hand side panel and the three PH2 screws along the back of the left hand panel.
3. Use a small flat bladed screwdriver to prise open the three clips holding the side panel to the appliance, then pull the side panel from back to front to release.
4. Repeat on the right hand panel, to remove both side panels.
5. Unscrew the four PH2 screws on the sides of the cross bar and the four PH2 screws underneath the cross bar.
6. Lift the cross bar off and away from the dishwasher cavity.
7. NOTE: Ensure that the crossbar is hooked back onto the cavity correctly during reinstallation.
8. Unscrew the two PH2 screws for the door lock on the crossbar. Unclip the door lock tabs away from the cross bar and pull away to release.
9. Unscrew the two PH2 screws for the door lock on the crossbar.
10. Use a small flat bladed screwdriver to flip up the wiring cover, then unravel the wiring from the door lock housing.
11. Carefully disconnect the wiring connectors from the door lock. Be careful not to damage any of the wiring connectors.
12. When assembling, repeat steps in reverse order.