Washing machine displays error message E90, E91, E92, E93 or E94
Resolution
Issue
- Washing machine displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- The door of the washing machine cannot be opened
- Clothing Wash Care Symbols
- Cleaning the washing machine’s rubber seal if it's dirty
- After cleaning the pump filter, the washing machine hums and does not start the wash cycle
- Washing Machine Installation Guide
- Washing machine stops in the middle of a cycle
- Zanussi Washing Machine Leaking Water – Causes and Solutions
- Laundry is stiff or hard after washing in washing machine
- The "drum cleaning" icon appears on the washing machine display
- Zanussi washing machine does not take detergents / water remains in the softener compartment
Related Articles
- The door of the washing machine cannot be opened
- Clothing Wash Care Symbols
- Cleaning the washing machine’s rubber seal if it's dirty
- After cleaning the pump filter, the washing machine hums and does not start the wash cycle
- Washing Machine Installation Guide
- Washing machine stops in the middle of a cycle
- Zanussi Washing Machine Leaking Water – Causes and Solutions
- Laundry is stiff or hard after washing in washing machine
- The "drum cleaning" icon appears on the washing machine display
- Zanussi washing machine does not take detergents / water remains in the softener compartment