Clothes are too creased after drying in tumble dryer
Issue
- Clothes are too creased after drying in tumble dryer
- Tumble dryer heats up too much
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Choose a suitable drying program.
Use a time program, do not dry too long.
Check your user manual for information about the drying time required for different types of laundry.
Download user manual
2. Remove the laundry immediately after the end of the programme.
If necessary extend the crease protection phase or use the start time delay (if available).
Note: Wool and duvet programmes have no anti-crease protection.
3. Do not exceed the maximum load stated in programmes chapter or shown on the display.
Was this article helpful?
Related Articles
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer’s water tank is empty
- Tumble dryer does not start / does not work
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Clothes are still wet at the end of the drying cycle
- Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up
Related Articles
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer’s water tank is empty
- Tumble dryer does not start / does not work
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Clothes are still wet at the end of the drying cycle
- Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up